Operations Guide

  • Mode Switch - changes the Mode and Frequency. To change the Mode and Frequency, press this switch repeatedly until the desired Mode and Frequency is indicated on LEDs.

 

  • POS LED - indicates that the unit is producing a Positive Waveform.   The LED flashes slowly to indicate that the unit is outputting a Waveform at 15Hz. The LED flashes faster (it may appear continuously “On”) when the unit is outputting a Waveform at 30Hz.

 

  • NEG LED - indicates that the unit is producing a Negative Waveform.  The LED flashes slowly to indicate that the unit is outputting a Waveform at 15Hz. The LED flashes faster (it may appear continuously “On”) when the unit is outputting a Waveform at 30Hz.

 

  • TIMED LED - indicates that the unit will produce a predefined sequence of output as follows: 13-cycles, each cycle consisting of 8-minutes of a Positive Waveform followed by 5-minutes of a Negative Waveform.

 

  • ON/OFFSwitch - turns the unit On and OFF.  This Switch may also be used to start the Battery Charging Sequence (see the Section on Charging).

 

  • LEVEL Switch - changes the Output-Level. To change Output-Level, press this switch repeatedly until the desired Output-Level is indicated on the respective LED.

 

  • 4V LED indicates the output is nominally 4VDC.

  • 8V LED indicates the output is nominally 8VDC.
  • 12V LED indicates the output is nominally12VDC.